Choose Christmas Light Clips by Surface

Map surfaces before counting

A single house can require several mounting types. Mark gutter edges, shingle rooflines, ridges, metal sections, driveways, and walkways on the job drawing. Keep a separate count for each surface so the crew receives the right hardware rather than one mixed bag that cannot finish every section.

Use O-Clips at gutters and shingles

Peak’s O-Clips are intended for gutters and shingle rooflines. Confirm their fit on the actual roof edge and supplied socket before ordering the full job. Inspect the surface condition and choose an attachment approach consistent with the product instructions and the property owner’s requirements.

Separate metal and ridge needs

Magnetic clips are for suitable magnetic surfaces. Metal appearance alone does not establish magnetic attraction: test the specific surface and fit. Ridge clips serve peaks along the top of houses. Verify the roof profile and clip fit before accessing the ridge, and use appropriate access equipment for the work.

Keep ground lighting upright

The ground stakes in this catalog are straight upright 7.5-inch stakes, used to line driveways and walkways. Record one or both sides and leave access routes clear. The calculator estimates one mounting piece per planned light point; confirm the actual mounting pattern and installation conditions. All four mounting types are sold in 100-count packs, so round each type independently.

Build a job-specific supply list

Use the free material calculator, compare mounting hardware, and review C9 bulbs, socket line and lamp wire, SPT-1 plugs, and clips and stakes.

For model-specific specifications or a bulk quote, call 817-538-8735.